欧美一区二区三区影视,成人精品免费在线观看,国产福利视频网站,三区精品,小情侣高清国产在线播放,国产一区三区视频,户外露出一区二区三区

common problem
常見(jiàn)問(wèn)題

1. The exhaust in the injection mold is not smooth, and there is often gas in the injection mold. What is the reason for this?

    The main reason for the failure is the air in the pouring system and mold cavity. Some raw materials contain moisture that has not been dried out. They will be vaporized into steam at high temperature. Because the temperature is too high during injection molding, some unstable plastics will decompose and produce gas; Some additives in plastic raw materials volatilize or produce gas through mutual chemical reaction. At the same time, the cause of poor exhaust also needs to be found out as soon as possible.

2. Stamping burr

    If the die clearance is too large or uneven, readjust the die clearance. 2. If the die material and heat treatment are improper, resulting in the inverted cone of the die or the cutting edge is not sharp, the material selection should be reasonable. The working part of the die should be made of cemented carbide, and the heat treatment method should be reasonable. 3. Punching wear, grinding punch or insert. 4. If the punch is too deep into the die, adjust the depth of the punch into the die. 5. If the guiding structure is not precise or the operation is improper, check and repair the guiding accuracy of the guide post and guide sleeve in the mold and the punch, and standardize the operation of the punch.

3. Difficulty in sprue stripping

    In the process of injection molding, the gate is stuck in the gate sleeve and is not easy to come out. When the mold is opened, the product is cracked and damaged. In addition, the operator must knock the tip of the copper bar out of the nozzle to loosen it before demoulding, which seriously affects the production efficiency.

    The taper hole of the gate has poor finish, and there are knife marks on the circumference of the inner hole. Secondly, the material is too soft, the small end of the taper hole is deformed or damaged after using for a period of time, and the spherical radian of the nozzle is too small, resulting in the rivet head of the gate material here. The taper hole of the sprue sleeve is difficult to machine, so standard parts should be used as far as possible. If it is necessary to machine by yourself, you should also make or buy a special reamer. The taper hole needs to be ground to above Ra0.4. In addition, the gate pull rod or gate ejection must be set.

黎平县| 海原县| 自贡市| 中方县| 徐闻县| 印江| 南充市| 新竹县| 黑山县| 乐业县| 塘沽区| 吉水县| 丽江市| 积石山| 大埔区| 仪陇县| 门头沟区| 澄迈县| 普兰县| 荔浦县| 安溪县| 民权县| 呈贡县| 瑞金市| 乐至县| 新巴尔虎右旗| 霍邱县| 怀柔区| 环江| 襄城县| 常州市| 固镇县| 绥中县| 监利县| 清徐县| 安吉县| 军事| 泰安市| 白银市| 泸西县| 昌图县|